WELCOME TO Hongkong NKF Machinery Co.,Limited. English | Spanish

v groove bearings

v groove bearings
Author :Admin | Publish Date:2012-12-17 08:57:48
This is a sketch from few months back showing how V-track might be a part of Contraptor. At that time, I looked at the prices of V-tracks and [v groove bearings]  and found them fairly expensive. Nevertheless I had ordered some material to build and test the prototype, and this weekend I finally got around to it.


Below are V-tracks that can attach to Contraptor angle or 1" T-slot. Fabricating wasn't too difficult but took some time. 3/16" holes were drilled in V-track at 2" intervals. 4" intervals could probably also work, but 2" fit nicely with 1ft and 2ft track lengths. One difficult thing was tapping small screw holes in the aluminum bar. I usually drill 1/8" hole and 6-32 screw self-taps into the hole with little effort. This works great in 1/8" thick aluminum. Here, the holes were about 3/8" deep and screws would stop dead after a certain point. I tried 6-32 tap in the power drill to save time and it broke on pull out after stopping too late. Basically the holes had to be tapped manually, advancing about quarter of a turn and then stepping back a couple of turns. Anyhow, this was only needed to be done once as they're not intended to be disassembled.


The timken bearing element still needs to be made. I only have 2 V-groove bearings from VXB.com and I'm trying to find them for a reasonable price (not $15 a piece). They are angular contact bearings so they can support combined loads and have very little axial play. The V-track + V-groove bearings with T-slot should be able to handle loads of a larger CNC machine - 1ft x 2ft and perhaps 2ft x 4ft.


V-groove bearings are designed as companion pieces to v-groove wheels, which allow for an object with bearings and wheels attached to roll along an elevated track. Movement of objects upon an elevated track is useful for locations where there is an excess amount of dust or floor-level debris. V-groove fag bearings and v-groove wheels are optimal for applications where each piece of track is parallel . to prevent an excess amount of wear occurring to one or both bearings. These bearings are basic straight-roller bearings which allows for minimal side-to-side movement. 


In applications where light loads are in transport, straight-roller bearings allow for radial movement, while more robust loads often require tapered internal bearings, which provide radial movement and thrust. Stainless steel is a common ingredient for these types of bearings. A v-groove is a v-shaped trench that travels the entire outer diameter of a wheel. This trench allows for the wheel and bearing to move back and forth while staying attached to the track. Devices of this design are specifically manufactured to allow for linear movement in a fluid manner that is free of obstruction. V-groove nachi bearings are typically available in four different styles: normal v-groove, studded v-groove, integral v-bearing and washdown.


AEL- 205 (25mm)
AEL- 207 (35mm)
MJH 18161 (NEEDLE BEARING)

Contact Us

TEL:00852-54978621
FAX:00852-54979628
Email:sales@dbearings.com
Add:UNIT 04,7/F BRIGHT WAY TOWER,NO 33 MONG KOK ROAD,KL
WhatsApp:8618112377009

ina information lists

Copyright © 2014 Hongkong NKF Machinery Co.,Limited. All rights reserved. TEL:00852-54978621 FAX:00852-54979628 Email:sales@dbearings.com